Locate a clean and flat level area free of stones
or sharp objects.
TIP: Let the liner sit under the sun for at least
two hours prior to installation; this allows the
liner material to be more flexible and ensure a
wrinkle-free fit.
STEP ONE: Prepare the site.
This Quick Start Guide provides a simple overview to your pool’s setup process.
For detailed setup guidelines, important safety information and useful tips, refer to the
enclosed “Funsicle QuickSet Pool User Guide.”
Ready. Set. Play.
QuickSet Pool
Quick Start Guide
Sign up for future
offers and discounts.
Scan the QR Code.
STEP TWO: Lay out the liner.
1. Inflate the air chambers following the numbered sequence (if any) slowly with a manual/foot
air pump. Use cold air only.
2. Check to confirm adequate air pressure. Your pool should be firm to the touch but not hard.
Do not overinflate. Refer to the enclosed User Guide for more information about air pressure.
3. Close and press the inflation valves into the unit to get a flat surface.
STEP THREE: Inflate the top ring.
To Next Page
Need help?
General
