- FILLING -
The Maximum water Level is right below the seam of the top sleeve of the liner; there is a printed mark
on the inside of the liner.
DO NOT LET THE WATER OVERFILL THE MAX LEVEL.
DRAIN WATER OVER THE MAX LEVEL WHEN FILLING OR AFTER EXCESSIVE RAIN.
- NOTE -
IF
MORE THAN 1-2 INCHES OF WATER COLLECTS ON ANY ONE SIDE BEFORE THE POOL STARTS
FILLING IN THE CENTER, THE POOL IS NOT LEVEL ENOUGH, AND MUST BE CORRECTED. DRAIN
THE POOL AND LEVEL THE GROUND
THE WEIGHT OF THE WATER WILL PREVENT ADJUSTMENT AFTER THIS POINT.
If your pool features a filter pump,
make sure the pump is connected to the pool’s wall before filling up completely and refer to the pump
instruction manual. As water gets into the filter thanks to gravity, it is necessary that all connections are
done before filling up, unless you have service plugs which can allow the connection of the filter after
the pool is being filled up.
- 17 -
To Next Page
Loading...
