DISTRIBUTED BY: Polygroup
®
Trading Limited
Unit 606, 6th Floor, Fairmont House, No.8 Cotton Tree Drive, Central, Hong Kong
INSTRUCTIONS FOR CHANGING
SFX FILTER TO SAND FILTER
OR RX FILTER SYSTEM
OWNER’S MANUAL
To replace your existing SFX Filter to a Sand Filter or RX Filter, simply assemble the new filter according the
following instructions.
1. Unpack the new filter you've purchased, and locate a round Seal Plate included.
2. Replace the SFX Motor with the Seal Plate following the steps shown below:
6) Remove the SFX Motor Assembly, and seal the Canister opening
with the Seal Plate. Fasten the Motor Seal Nut tightly to ensure
that no water leaks.
4) Remove the Top Cover, Strainer Basket, and Filter Cartridge.
Use a water container (e.g. a bucket, not included) to collect
the purged water resulting from servicing the pump.
1) Insert the Water Stopper into the pump’s water intake. Push the
stopper tightly into the Skimmer Seal Ring.
3) Detach the Locking Ring and RF Diverter by turning
counterclockwise. Insert the Service Plug.
2) Unplug the power.
Water Stopper
Skimmer Seal Ring
RF Service Plug
Locking Ring
RF Diverter
Top Cover
5) Remove the Motor Seal Nut by turning it clockwise. Do not pull
or push the canister, as this can cause damage between the
canister and pool liner.
Motor Seal Nut
To Next Page
General