The 3D Goggles must be worn to see the goggles to see 3D effects
Care Instructions:
1. Pool can be cleaned with mild soap and lukewarm water only.
2. Rinse goggles with cold tap water before storage.
3. Air-dry goggles, and store in dry place. Do not store in direct sunlight.
4. Do not store pool in temperatures below 32º F or above 125º F.
5. Use a small patch kit to repair punctures or holes in pool.
6. Waterproof patches may be purchased at polygroupstore.com
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
MST. Extended operating days and hours during peak season requirements.
321
GOGGLE INSTRUCTIONS
Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
Wearing Goggles:
• Remove protective film from goggles lens before use.
• Adjust goggle head strap and bridge strap to a proper and comfortable position. The head strap is used to hold the
goggles in place.
• Tighter is not necessarily better, as this may cause discomfort and marking around the eyes.
• Correct adjustment can be obtained by tensioning the band until a comfortable fit is achieved.
• Correct adjustment of the bridge strap is essential for both comfort and a watertight seal.
• To avoid water intake, slide the lenses closer together or further apart one notch at a time until the correct fit is obtained.
• To clear water or to adjust goggles, take a firm grip on the eye cup and tilt the lower edge of the eye cup slightly away
from the face.
• To remove goggles, put thumbs under head strap at side of head. Slide thumbs to back of head, and lift elastic from
back to front of head.
• It is recommended that teachers, coaches, or mature swimmers demonstrate this method to young children.
To Next Page
Loading...
