EasyManua.ls Logo

Polygroup Summer Waves Maintenance Kit - Vacuuming With A 5;8 Garden Hose

Polygroup Summer Waves Maintenance Kit
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
MST. Extended operating days and hours during peak season requirements.
OWNERS MANUAL
To Vacuum With A 5/8” Garden Hose (Not Included)
3. Attach the vacuum bag to the vacuum head, tighten the
drawing string and tie a simple shoelace knot.
4. Twist off the water hose cap.
5. Hand tighten a 5/8” garden hose to the vacuum head.
6. Slip the hose into the hose clip. 7. Place the vacuum under water.
8. Turn on the water supply, it will create a venturi action at
the vacuum head to collect the debris inside the vacuum bag.
9. Slowly push the vacuum head across the pool floor to remove debris.
10. When done or the bag is full:
(1) Slowly move the vacuum head to the side wall of the pool, turn the vacuum head up-side-down, shut off the water and lift the vacuum head out of the pool.
(2) Remove the vacuum bag and discard all the debris, flip the bag in-side-out and rinse with running water.
11. Repeat the vacuuming process until the pool is thoroughly cleaned.
Hose Clip
5/8” hose
4
2. Attach the vacuum head to the open end of the telescopic pole.
1. Extend the telescopic pole to its fullest length.

Related product manuals