Head Restraints
To raise the height of the head restraint, pull the head
restraint up. To lower the height of the head restraint,
push in the locking clip at the base of the head restraint
and push the head restraint down. The locking clip
needs to be pushed outboard on the driver’s side head
restraint and inboard on the passenger’s side. The
upper edge of the head restraint should be about at eye
level, never at neck level. This position reduces the
chance of a neck injury in a crash.
Seatback Latches
The front seatbacks fold
forward to let people get
into the back seat.
To fold a front seatback forward, lift the entry lever
located near the top of the outboard shoulders of each
front seat. Then tilt the seatback forward. To move
the seat forward, push the button located below
the seatback latch. Then move the seat forward.
For safety of front seat passengers, a weight sensor
has been built into the front seats. The seat will
not move forward if there is more than 27 lbs (12 kg) on
the seat sensor.
1-4
To Next Page
Loading...
Need help?
General
