4. Disconnect the bulb
base from the socket
by lifting the plastic
locking tab.
5. Snap a new bulb into the socket.
6. Reinstall the bulb assembly by reversing
Steps 1 through 3.
Front Turn Signal and Parking
Lamps
To replace one of your front turn signals or parking
lamps, do the following:
1. Remove the shield following Step 1 under
Headlamps on page 5-44
.
2. Hold down the tab at
the top of the retainer.
Twist the bulb
retainer one-eight
of a turn
counterclockwise and
pull the assembly out.
3. Remove the bulb from the assembly by pulling the
bulb straight out.
4. Snap a new bulb into the socket.
5. Reinstall the bulb assembly by reversing
Steps 1 and 2.
5-45