Pool Frog 6100 - Using FROG BAM for Algae Protection

11
Using FROG BAM
®
for an Algae-Protection Guarantee
1.
If you are not using FROG BAM
®
, refer to page 12 for Using the
POOL FROG
®
Bac Pac. See FROG BAM
®
product labeling for
complete directions for use (EPA Reg. No. 53735-9).
For a preventive dose add:
•One FROG BAM
®
for pools up to 15,000 gallons.
•Two FROG BAM
®
for pools between 15,000 and 30,000 gallons.
Remove cap from FROG BAM
®
without removing seal.
Insert upside down into center
of POOL FROG
®
Mineral
Reservoir pushing down rmly
on FROG BAM
®
bottle allowing
key in POOL FROG
®
Cycler to
puncture seal.
Replace cap by hand only.
DO NOT OVER TIGHTEN.
Turn control dial on POOL
FROG
®
Cycler to Setting 10.
2.
3.
4.
5.
Turn pump on for 90 minutes
allowing FROG BAM
®
to circulate
through pool.
6.
To remove expended FROG
BAM
®
, bottle turn pump off. Turn
dial to Setting 0.
7.
Remove POOL FROG
®
Cycler
cap.
8.
Lift FROG BAM
®
up and allow any
water in the container to drain
through the POOL FROG
®
Cycler
before discarding in trash.
NOTE: If water shows more
than a hint of blue inside POOL
FROG
®
Cycler, replace the
POOL FROG
®
Cycler cap, turn
dial to Setting 10 and run the
pump for one minute.
8a. If pool size requires
additional FROG BAM
®
, repeat
steps 1-8.
8b. When water is clear in
POOL FROG
®
Cycler, proceed to
Using a POOL FROG
®
Bac Pac
on page 12.
*NOTE: If using directly after a shock treatment, test the water rst to ensure the pH is in the proper range of 7.2-7.8 and the chlorine
level is no more than 4.0 ppm. Avoid using other chemicals until this product has been circulated (ltered) for at least 24 hours.