POWER SUPPLY AND CONTROLLER
The Pool Lab power supply and controller is supplied with a mounting bracket, three
screws and three masonry plugs. To comply, the unit must be mounted on a solid wall or
post that covers an area no less than the rear area of the back of the power pack. Always
mount the power pack as per local electrical codes and within 3m (9 feet) of the cell and
2m from the pool pump. Air flow around the power supply must not be restricted or close to
any heat source such as a gas heater exhaust.
The unit is suitable for outdoor installation and has an IP23 rating. This allows the unit to
be installed either 1.2m higher than the highest water level or at least 3m from the pool
edge as defined in AS3000 section G.3.
The power supply and controller has a built in digital time clock which will control both the
chlorinator and pump ON and OFF times. For the built in safety features and timers to
operate correctly the pump should be connected directly to the pump outlet socket on the
bottom of the unit.
You may use an external time clock to control the chlorinator and pump, however some of
the delay features involving the pump will not operate.
WARNING - ISOLATE AND DISCONNECT SUPPLY POWER BEFORE SERVICING
CHLORINATOR OR PUMP.
CAUTION - FOR CONTINUED PROTECTION AGAINST POSSIBLE ELECTRIC SHOCK
USE ONLY IDENTICAL REPLACEMENT PARTS WHEN SERVICING.
21
To Next Page
Loading...
