No Diving or Jumping. Observe all Safety Rules.
3-1
A. Assemble your Pool Wall
This section is for Round and Oval pools (ROUND POOLS ARE SHOWN).
1. Set the Pool Wall in place
a. Wait for a calm day. Do not attempt to install the pool wall in the wind.
b. Unpackage the coiled pool wall and
stand it on a piece of cardboard or
plywood at the centre of the pool.
The cut-outs for the through-the-wall
skimmer should be towards the top
of the wall. Look for a “this way up”
label and arrow. Make sure the skim-
mer and water return holes are where
you need them to be. The skimmer
and water return holes are positioned
towards the end of the pool wall.
(The section before the wall started).
c. Start uncoiling the wall, guiding the
bottom edge into the curved bot-
tom rail. The starting end of the wall
must be positioned over a bottom-
plate, and the skimmer and return
holes should be positioned where the
pumpandlterwillbe.Set lengths
of Omega Stabilizer onto the top
edge of the wall as you uncoil it.
2
Section
Pool Component Installation Manual
Assembling the Pool
Wall & Liner
3
Caution:
Do not attempt to install
the pool wall in the wind.
Wait for a calm day.
Hint:
Secure the omega stabiliz-
er to the wall with a piece
of duct tape after instal-
lation to prevent it from
lifting off the wall.
Hint:
Bring the following items
onto the pool foundation
before you start uncoiling
the pool wall: the pool
liner, some extra brick
sand to make the cove in
Step 5, and a ladder to
climb out after the wall is
assembled.
1
4
3
To Next Page
Loading...