PoolPak PCP Series – Outdoor OMM 12 September 2020
Equipment Specific Data
Specific information for individual dehumidifiers is provided in the following methods:
Main Label (Pic. C.5): the manufacturer tag
attached to the front of the dehumidifier
includes the dehumidifier’s most critical data:
General data including:
o Serial number
o Dehumidifier model
(nomenclature)
o Design room conditions (air
temperature and humidity)
Operational data, including:
o Refrigeration (refrigerant type,
charge, etc.)
o Electrical/airflow (dehumidifier
voltage, CFM, etc.)
o Other applicable data (pool heating,
space/auxiliary heating features,
etc.)
Labels and Stickers: attached when applicable to
the exterior and interior of the dehumidifier to
show:
External systems connections
location/direction
(pool/space heating, cooling circuits,
condensate)
Air filter locations, quantity, and size.
Additional Info (warning, caution stickers, etc.)
Wiring Diagrams: attached to the interior side of
the dehumidifier, depict dehumidifier control and
power wiring.
Remotely installed condenser or cooler would have its specific information provided in similar manner (labels etc.).
Attention! Glycol Circuits.
Unless otherwise indicated, equipment fluid circuits (except for refrigeration and pool water circuits) such as heat
recovery loop, compressor glycol loop, fluid cooler etc., are normally filled/to be filled with water/glycol mixture;
normally, rust inhibitor-infused food-grade propylene glycol is used.
Glycol mixture concentration is normally shown on Main Label – refer as needed.
To Next Page
Loading...