To Next PageTo Next Page
Need help?Do you have a question about the PoolPak HCD 1200 and is the answer not in the manual?
General| Brand | PoolPak |
|---|---|
| Model | HCD 1200 |
| Category | Dehumidifier |
| Language | English |
Overview of methods for controlling humidity, temperature, and ventilation.
Uses mechanical refrigeration and heat recovery; higher first cost, lower operating cost.
System overview, vapor compression cycle, and heat recycling for efficiency.
How the system manages humidity, temperature, and recycles energy for comfort.
Microprocessor control system sensing and maintaining comfort conditions automatically.
Advanced control method for maintaining moisture levels below damaging thresholds.
Airflow through evaporator, refrigerant cycle, and heat transfer for dehumidification.
Micro-processor system for managing pool enclosure humidity and air/water temperatures.
Activates compressor based on dew point and directs recovered heat for space/water heating.
Sensor measures coldest surface temp to adjust humidity setpoint, preventing condensation.
Connects up to four units for coordinated control of temperature and humidity.
Lists standard factory-mounted and field-supplied features and system options.
System selection based on application type (AW Series vs. HCD Series).
Utilizes ECC-PCP technology with RAP for remote access and BAS integration.
Key performance and dimensional data for RoofPak models.
Detailed performance data for PoolComPak AW units.
Performance summary table for AW series units.
Performance summary table for HCD series units.
Factory refrigerant R410A charge for units with ACC and WCC.
Performance chart for remote ACC models, including piping and electrical data.
General requirements for unit placement, piping, and electrical connections.
Details on fused disconnects, wire sizing, ground connections, and NEC compliance.
Description of field wiring for the ECC-PCP system.
Installation guidelines, water chemistry, flow rate, and pressure drop for pool water piping.
General guidelines for installing refrigerant piping by qualified mechanics.
Material recommendations, brazing, inert gas flow, and support for piping.
Guidelines for sizing lines to ensure oil carryover and prevent pressure drops.
Procedures for charging refrigerant and oil, including sample calculations.
Description of the RIU keypad and basic operation.
How to access and change set points for temperature, humidity, and pool water.
Master/slave operation, network roles, and status screens.
Configuring network parameters like water temp control, staged dehumidification.
Accessing the service menu and sub-menus like I/O Configuration.
Information on the last 50 faults for troubleshooting.
Importance of periodic maintenance for equipment life and problem prevention.
Comprehensive diagram showing field wiring for various components and options.
