To Next PageTo Next Page
Need help?Do you have a question about the PoolPak ComPak HCD 1800 and is the answer not in the manual?
General| Brand | PoolPak |
|---|---|
| Model | ComPak HCD 1800 |
| Category | Dehumidifier |
| Language | English |
Safety guidelines for installation, operation, and maintenance to prevent injury or damage.
Addresses pollutants, chloramines, and ventilation for healthy air.
Explains the vapor compression cycle and heat recycling process.
Describes the microprocessor control system for comfort regulation.
Details advanced control using dew point for moisture management.
Describes the CPCS-PCP controller and its remote interface unit.
Explains how dew point is managed for humidity control.
Mentions CPCS-PCP technology, remote access, and available heating options.
Presents detailed performance metrics for AW models.
Details performance metrics for HCD models.
Describes field wiring for the control system and remote interface unit mounting.
Details initial configuration steps for the control system.
Describes the RIU keypad, display, and navigation.
Describes master/slave operation and network configuration parameters.
Instructions for accessing the service menu with password.
Explains digital inputs, outputs, and analog inputs.
Parameters related to compressor control and economizer operation.
Instructions and parameters for operating the unit in manual mode.
Accessing units, passwords, time/date, and pre-startup checks.
Steps for performing startup and contacting PoolPak Service.
General troubleshooting steps for system issues.
Lists and explains common fault conditions detected by the control system.
Procedure for downloading operational data for analysis.
Table detailing common symptoms, causes, and solutions for unit issues.
General field wiring schematic showing terminal connections.
Main schematic for single-phase ComPak units.
Main schematic for three-phase ComPak units.
Verifies proper installation of unit, ductwork, and piping.
Critical checks before power application and fan motor verification.
Procedures to test auxiliary air heat and compressor modes.
Tests for compressor reheat, pool heating, and air cooling modes.
