To Next PageTo Next Page
Need help?Do you have a question about the PoolPak HCD 4000 and is the answer not in the manual?
General| Brand | PoolPak |
|---|---|
| Model | HCD 4000 |
| Category | Dehumidifier |
| Language | English |
Discusses condensation, mold growth, metal corrosion, and structural damage caused by excess humidity.
Explains the PoolPak system's function in dehumidifying pool air via vapor compression and heat recycling.
Details the microprocessor control system for maintaining comfort conditions and preventing condensation.
Describes the advanced dew point control method for precise moisture management in pool areas.
Overview of the ECC-PCP controller for managing pool enclosure humidity and temperatures.
Key performance data and specifications for RoofPak AWH/HCDH models.
Performance summaries for PoolComPak AW (AWV, AWH) models at specific operating conditions.
Performance summaries for PoolComPak HCD (HCDV, HCDH) models at specific operating conditions.
Factory refrigerant R410A charge details for various PoolComPak models and condenser types.
Covers unit placement, utility connections, ductwork, and condensate piping for PoolComPak units.
Details on wiring the ECC-PCP system, including the remote interface unit and sensor connections.
Instructions for mounting and wiring the cold surface temperature sensor for condensation prevention.
Instructions for piping pool water to and from the unit, including flow control and water chemistry.
Recommendations for installing refrigerant piping, including materials, brazing, and support.
Procedures and calculations for charging refrigerant and oil for ACC units and linesets.
Description of the RIU keypad, display, and navigation for system control.
Guide to adjusting air temperature, relative humidity, and pool temperature set points.
How networked units operate in a master/slave environment for coordinated control.
Diagram showing field wiring connections for various sensors, controls, and systems.
