10
Step 1
Clean the top groove of any sand that may be
inside before installing the gasket.
Step 2
The cover (A) and the lter body (B) are
equipped with a notch (C, D) to indicate the
mounting orientation of the cover. Make sure
these notches line up perfectly with each
other.
Step 3
Install the clamp ring so that it encircles the
ange of the cover and of the lter shell.
Secure using the screw (6) and the washer
(7) on one side, and the m8 nut (25) on the
other, and tighten it using a suitable screw-
driver.
Installing the control cover
Warning :
The presence of sand or any other foreign body in the groove or on the seal can cause
a leak or even an explosion of the ltration unit.
23
24
6
7
25
To Next Page
Loading...