No. 8
No. 7
No. 6
Connect only to a drinking water supply. Water pressure must
be a minimum of 1 Bar 15 psi up to a maximum of
6 Bar 88 psi. Water temperature ideally must be between
+5°C and +20°C.
The machine can be either connected by flexible hose provided
or run in copper pipe. The connection is
3
/4 inch BSP.
Drain pipe for melt/waste water must be run with a minimum
15% incline and be taken to a suitable open vented drain. It is
important the drain pipe is not in contact with any part of the
drain system. A tun dish type is ideal. A ‘u’ bend can be built
in to the drain line. IT IS ESSENTIAL THAT NO REFLUX
OR CONTACT WITH THE DRAINS SHOULD OCCUR.
To Next Page
Loading...
