Multi-Purpose Display and Instruments 153
Setting the tire type and size
Warning!
Incomplete entries or selection of the wrong
tires on the multi-purpose display affect
correct indication of warnings and
messages.
f The settings must be updated in the TYRE
PRESSURE menu after changing a wheel, filling
with tire sealant or adding air (after previous
warning ”Flat tyre“).
f Please observe the chapter “”FLAT TYRE“
WARNING” on Page 155.
The settings of the multi-purpose display must be
updated after changing wheels or tires on the
vehicle.
The tire type and tire size must be selected even
if the settings for the new set of wheels are the
same as for the old wheels.
After driving off, the system starts to teach the
wheels and wheel positions on the vehicle. During
this time, the tire pressure warning light on the
speedometer flashes about 60 seconds and lights
up thereafter permanently, and no current tire
pressure information is available on the displays.
Note
Information on the tire size and type can be found
on the tire sidewall. For further information on the
details on the tire sidewall:
f Please observe the chapter “INSCRIPTION ON
RADIAL TIRE” on Page 319.
Note on operation
Before fitting tires approved by Porsche with a
size which is not already stored in the multi-
purpose display, the missing information should
be supplemented in the multi-purpose display.
f Go to an authorized Porsche dealer
immediately.
6.
1. MAIN MENU
>TYRE PRESSURE
>SETTINGS
Select and confirm.
2. Select TYRES.
3. Confirm selection.
The TYRE TYPE list is displayed.
4. Select tire type (e.g. SUMMER).
The list with the possible tire sizes
(e.g. for the selection SUMMER) is
displayed.
5. Select tire size (e.g. 18 inch).
6. Confirm selection.
The current settings are displayed.
To Next Page
Loading...
Need help?
General
