QUICK SETUP SHEET
portable
evaporative
cooling units
1
2
FILL WITH WATER
• Connect with standard garden hose or
ll manually
• Once the tank is lled, the water hose can
be disconnected.
IF USING INDOORS
• Place back of unit near a slightly opened
window or door.
• A window or door on the opposite side of
the room should be le slightly open.
3
For more information, please see the owner’s manual included with your Port-A-Cool® unit
Call (936) 568-5651 or visit www.port-a-cool.com/cycloneproducts.html
ADJUSTING WATER FLOW
FOR OPTIMAL COOLING
• Turn pump on so water is owing over pads
• Turn fan on and run for 5 minutes
• Adjust water ow to achieve narrow dry streaks on pads
•Turn water valve to the right if no dry streaks are present
• Turn water valve to the le if large areas of dry pad
are present
• Allow 5 minutes between adjustments
MAX
MIN
The water flow valve on each unit is set at
max flow. Adjust as needed before use.
CAUTION: Do not run pump
when water tank is dry.
Initially, there
may be some
odor emitted from
the pads. This
disappates after
1-3 weeks of use.
Scan the QR code
for more
information.
To Next Page
Need help?
General
