Portable Partitions VP6

To Next Page

Versare Portable Products 3236 California Street NE Minneapolis, MN 55418

Phone: 800-830-0210 Fax: 800-310-4874 WWW.portablepartitions.com

VP6 Assembly Instructions

Recommended Tools

Step #1 Remove the Partition from the box.

Step #2: There are 4 tubes, two equal

length, one without plastic ends, one with.

Step #3: Install the longer tube without

plastic ends to the caster base as shown.

Note the location of the support struts

Step #4 Install screws as shown,

repeat for opposite end.

Step #5 Insert one of the two shorter

tubes as shown.

•Cordless drill with Phillips

bit (or standard Phillips

screwdriver)

•Adjustable wrench

Support Struts

Need help?

Do you have a question about the Portable Partitions VP6 and is the answer not in the manual?

Summary

Lists the essential tools required for assembly, such as a cordless drill and adjustable wrench.

Covers removing the partition from the box, identifying tubes, and attaching the longer tube to the caster base.

Details inserting shorter tubes, securing them with screws, and installing all four casters to the base.

Includes draping the partition panel, securing it with Velcro, and installing the support struts.

General