10
Mixing & Filling
• Read the product label and follow the instructions carefully, taking special note with regard
to the order in which the products are added to the tank.
• Calibrate your sprayer according to the calibration method on page 9 using water only.
Calibration must be done with the nozzle tip that has been selected for the spraying task.
• Measure out the correct quantity of pesticides using clean measuring jugs used only for this
purpose.
• Half fill the SprayMaxx with clean water, then add the measured pesticide/chemical.
• Rinse out the measuring jug and empty the container. Pour all rinsings into the spray tank.
Agitate by stirring with a suitable round edged paddle.
• Top up the tank with water to the required level, ensure that the tank is not over-filled and
the outside is clean and dry before handling.
• Safely dispose of empty containers in compliance with current regulations.
• Mixing sites must be well away from watercourses and other environmentally sensitive
areas. Children and animals must be kept away.
To Next Page