4
SPECIFIC SAFETY RULES AND SYMBOLS FOR LOCK
MORTISER
1. CAUTION: DO NOT OPERATE MOTOR UNIT UNLESS MOUNTED IN
LOCK MORTISER CARRIAGE.
2. BE SURE CORD IS FREE and will not “hang up” during operations.
3. KEEP HANDS CLEAR OF CUTTER when motor is running to prevent
personal injury.
4. STAY ALERT and keep cutter clear of all foreign objects while motor is
running.
5. BE SURE MOTOR HAS COMPLETELY STOPPED before withdrawing
cutter from machined mortise.
6. SOME WOOD CONTAINS PRESERVATIVES WHICH CAN BE TOXIC.
Take extra care to prevent inhalation and skin contact when working with
these materials. Request, and follow, any safety information available from
your material supplier.
7. WARNING: There are certain applications for which this tool was
designed. Porter-Cable strongly recommends that this tool NOT be modified
and/or used for any application other than for which it was designed. If you
have any questions relative to its application DO NOT use the tool until you
have written Porter-Cable and we have advised you.
Technical Service Manager
Porter-Cable Corporation
4825 Highway 45 North
Jackson, TN 38305
SYMBOL DEFINITION
V ........................ volts
A ........................ amperes
Hz ........................ hertz
W ........................ watts
kW ........................ kilowatts
µF ........................ microfarads
l ........................ liters
kg ........................ kilograms
N/cm
2
........................ newtons per square centimeter
Pa ........................ pascals
h ........................ hours
min ........................ minutes
s ........................ seconds
........................ alternating current
3 ........................ three-phase alternating current
3
N ........................ three-phase alternating current with neutral
........................ direct current
n
0
........................ no load
........................ alternating or direct current
........................ Class II Construction
........................ splash-proof construction
To Next Page
Loading...