3
8. DISCONNECT TO O L FROM AIR
SUPPLY HOSE before doing tool
maintenance, clearing a jammed fastener,
leaving work area, moving tool to another
location, or handing the tool to another
person. Fig. 5.
9. NEVER USE A TO O L that is leaking air ,
has missing or damaged part s, or requires
rep air. Make sure all screws and cap s are
securely tightened. Fig. 5.
10. NEVER USE TO O L IF SAFETY,trigger
or springs are inoperable, missing or
damaged. Do not alter or remove safety,
trigger , or springs. Make daily inspections for
free movement of trigger and safety
mechanism. Fig. 5.
11. DO NOT USE TO O L WITHOUT
SAFETY W ARNING LABEL. If label is
missing, damaged or unreadable, contact
your Porter-Cable Service Center for a
replacement. Fig. 6.
12. O N LY USE PARTS, FASTENERS, A N D
ACCESSORIES recommended by Porter-
Cable. Fig. 7.
13. CONNECT TO OL TO AIR SUPPLY
BEFORE loading fasteners, to prevent a
fastener from being fired during connection.
The tool driving mechanism may cycle when
tool is connected to the air supply. Fig. 8.
14. ALW AYS ASSUME THE TO O L
CONTAINS FASTENERS. Keep the tool
pointed away from yourself and others at all
times. No horseplay. Respect the tool as a
working implement.
15. DO NOT LOAD FASTENERS with
trigger or safety depressed, to prevent
unintentional firing of a fastener . Fig. 9.
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
To Next Page
Loading...
