To Next PageTo Next Page
Need help?Do you have a question about the Porter-Cable NS100A and is the answer not in the manual?
General| Staple Capacity | 100 staples |
|---|---|
| Power Source | Pneumatic |
| Staple Gauge | 18 gauge |
| Operating Pressure | 70-120 PSI |
| Magazine Capacity | 100 staples |
| Manufacturer | Porter-Cable |
| Staple Type | 18 Gauge Narrow Crown Staples |
| Type | Staple Gun |
Wear safety glasses with permanently attached rigid plastic side shields conforming to ANSI Z87.1.
Wear ear protection to safeguard against possible hearing loss.
Operate tool with clean, dry, regulated compressed air between 70 and 120 PSI.
Do not connect the tool to air pressure exceeding 200 PSI (13.7 BAR).
Use air hose rated for minimum working pressure of 150 PSI or 150% of system pressure.
Never use oxygen, carbon dioxide, or combustible gases as a power source to avoid explosion.
Use an air coupling that removes all pressure from the tool when disconnected.
Disconnect air supply before maintenance, clearing jams, moving, or handing over the tool.
Use trigger fire for accuracy or bottom fire for rapid placement.
