2
Fig. 4
Fig. 1
Fig. 2
Fig. 3
IMPORTANT SAFETY INSTRUCTIONS
W ARNING: When using pneumatic tools, basic safety precautions should
always be followed to reduce the risk of personal injury, including the
following:
READ AND FOLLOW ALL INSTRUCTIONS.
There are cert ain applications for which this tool was designed. Porter-Cable
strongly recommends that this tool NOT be modified and/or used for any
application other than for which it was designed. If you have any questions
relative to its application DO NOT use the tool until you have written Porter-
Cable and we have advised you.
Technical Service Manager
Porter-Cable Corporation
4825 Highway 45 North
P. O. Box 2468
Jackson, TN 38302-2468
1. USE SAFETY GLASSES. To prevent
eye injuries, the tool operator and all persons
in the work area must wear safety glasses
with permanently att ached, rigid, plastic side
shields. These safety glasses must conform
to ANSI Z87.1 requirements (approved
glasses have Z87 printed or st amped on
them). Fig. 1.
2. WEAR EAR PROTECTION to safe-
guard against possible hearing loss. Fig. 1.
3. USE CLEAN, DRY, REGULATED com-
pressed air at 70 to 120 PSI. Fig. 2.
4. D O N O T C O N N E C T TO O L T O pressure
which potentially exceeds 200 PSI (13.7
BAR).
5. O N LY USE AIR HOSE THAT IS
R AT E D for a minimum working pressure of
150 PSI or 150% of the maximum system
pressure, which ever is greater.
6. NEVER USE OXYGEN, CARBON
DIOXIDE, combustible gases or any other
bottled gas as a power source for this tool:
explosion and serious personal injury could
result. Fig. 3.
7. CONNECT TO O L TO AIR SUPPLY
HOSE with a coupling that removes all
pressure from the tool when the coupling is
disconnected. Fig. 4.
To Next Page
Loading...
