Porter-Cable PCC710B - Troubleshooting; Unit Will Not Start; Unit Starts Immediately; Battery Pack Not Charging

12
TROUBLESHOOTING
Problem Possible Cause Possible Solution
•Unitwillnotstart. •Batterypacknotinstalledproperly. •Checkbatterypack
installation.
•Batterypacknotcharged. •Checkbatterypack
charging requirements.
•Unitstartsimmediately •Theswitchhasbeen •Theswitchmustbemoved
upon inserting battery. left in the “on” position. to “off” to prevent the tool
from immediately starting
when battery is inserted
•Batterypackwillnotcharge. •Batterypacknotinsertedintocharger. •Insertbatterypackinto
charger until LED lights.
•Chargernotpluggedin. •Plugchargerintoa
working outlet. Refer to
“Important Charging Notes”
for more details.
•Surroundingairtemperature •Movechargerandbattery
too hot or too cold. pack to a surrounding air
temperature of above 40
degrees F (4,5°C) or below
105 degrees F (+40,5°C).
•Unitshutsoffabruptly. •Batterypackhasreachedits •Allowbatterypacktocool
maximum thermal limit. down.
•Outofcharge.(To •Placeonchargerand
maximize the life of the allow to charge.
battery pack it is designed
to shutoff abruptly when
the
charge is depleted.)