GAM Quick Installation Guide
Positron Access Solutions 25 Document 180-0204-001 R03
A number of application scenario rely on connecting a 1
st
GAM device to a GAM-4-MRX
or GAM-8-MRX and use Link Aggregation (LAG) for 4 or 8 G.hn MIMO ports to achieve
multi-gigabit services between those GAM devices.
In this case, there is a need to install a mid-span GAM-PWR-4-M power injector alongside
a first locally powered indoor GAM to act as the RPF PSE device instead of using
individual G1001-MR devices. This is achieved as per the following diagram.
The use of a GAM-PWR-4-M mid-span injector requires specific wiring to allow the injection of
the Reverse Power Feed on the G.hn MIMO pairs toward the GAM-4-MRX or GAM-8-MRX.
Please refer to the GAM-PWR-4-M Quick Installation Guide (document 180-0216-001) for more
information.
To Next Page
Loading...