EasyManua.ls Logo

Potter VSR-SG - Testing and Electrical Connections; Testing Frequency and Procedure; Electrical Connection Options

Potter VSR-SG
4 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PRINTED IN USA MFG. #5401205 - REV H
01/12
PAGE 2 OF 4
VSR-SG
VANE TYPE WATERFLOW
ALARM SWITCH WITH RETARD
AND GLUE-IN UNION
FOR CPVC PIPE
Notes:
 
central station, proprietary or remote signaling unit, while the other

 

Fig. 4 Typical Electrical Connections

conduit entrance.
Testing




Fig. 2
Important:
11 paddles are furnished with each unit
     
manufacturers of TEES. The paddles have
raised lettering that show the pipe size and
the TEE manufacturer they are to be used
with. The proper paddle must be used. The


securely tightened.
Fig. 1


preparation and gluing of CPVC piping
systems. Wait 2 to 4 hours to allow the glue


Fig. 3
DWG# 1205-4

with the testing instructions.
LOAD TO BELL
NEUTRAL FROM BELL
CONNECTOR
EOL (End Of Line Resistor)
BELL
NEUTRAL FROM BREAKER
BREAKER
LINE FROM BREAKER
NOTE:
When connecting to a UL Listed
control panel, use the panel’s
resistor value for circuit supervision.

Related product manuals