pottery barn kids BELDEN BUNK BED User Manual

Date: Oct.24, 2012 Page 1 of 6
Rev.
pottery barn kids
BELDEN BUNK BED
PRE-ASSEMBLY:
Remove all parts and hardware from the box and place them on a clean carpeted, or scratch-free work surface (The
shipping box provides an ideal work surface). This will avoid damaging any parts during assembly.
To avoid accidentally discarding small parts or hardware, do not dispose of any contents until assembly is complete.
Two people are recommended for ease of assembly.
Prior to starting assembly, use the parts and hardware lists to identify and separate each of the pieces included.
The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
Note: Do not fully tighten all th bolts until all parts are in place. Failure to follow these instructions may cause the bolts
to misalign during assembly.
Please use caution if using power tools to aid in assembly . Power tools can damage hardware or split wood.
PARTS INCLUDED:
A – Footboard (1)
B – Headboard (1)
C – Guardrail (2)
D – Right side panel (1)
E – Bottom frame with drawers (1)
F – Left side panel (1)
G – Slat rolls (2)
H – Ladder (1)
TOOLS REQUIRED:
Phillips head screwdriver (not included)
T – Allen Key (included)
HARDWARE INCLUDED:
I – Long Hex Bolt 5/16”x100mm (20) J – Short Hex Bolt 1/4”x63mm (8)
K – Short Hex Bolt 1/4” x 32mm (7) L – Spring Washer 5/16”x13x1.5 mm (20)

pottery barn kids BELDEN BUNK BED Specifications

General

Brand	pottery barn kids
Model	BELDEN BUNK BED
Category	Indoor Furnishing
Language	English

Summary

BELDEN BUNK BED Pre-Assembly and Component Guide

Prepare Assembly Area and Parts

Use a clean, scratch-free surface for assembly and identify all parts before starting.

Handle Hardware Safely

Avoid discarding hardware until assembly is complete and use caution with power tools.

Component Identification

Lists included parts: Footboard, Headboard, Guardrail, Side Panels, Bottom Frame, Ladder, and Slat Rolls.

Required Tools

Lists Phillips head screwdriver and Allen Key as necessary tools for assembly.

BELDEN BUNK BED Assembly Steps

Drawer and Bottom Frame Assembly

Pull out drawers from the bottom frame and attach levelers using screws.

Side Panel and Ladder Attachment

Connect side panels to the bottom frame and attach the ladder to the footboard.

Guardrail and Panel Securing

Attach guardrails to footboard/headboard and secure side panels using bolts and nuts.

Bottom Frame and Slat Installation

Attach the bottom frame, adjust levelers, and install slat rolls with screws.

Final Tightening and Drawer Insertion

Fully tighten all bolts and screws, then re-insert the drawers into the bottom frame.

Slat Roll Attachment and Final Check

Attach slat rolls using screws, tighten all hardware, and check for stability.