Page 3 of 3
3. Attach Leg Supports (D) to the Slats (E) by inserting the Allen Bolt (H) through the hole on the slats into the insert
on the leg supports as shown in fig. 2.
4. Lay the Slats (E) in place over the slat support on the side rails and insert the Screws (F) into the holes at the end
of the Slats (E). Tighten with a screwdriver (Not Included) as shown in fig. 3, illustration. 2.
Care Instructions:
• Dust often using a clean, soft, dry and lint-free cloth.
• Blot spills immediately and wipe with a clean, damp, cloth.
• We do not recommend the use of chemical cleansers, abrasives or furniture polish on our lacquered finish.
To Previous Page
Loading...
