To Next PageTo Next PageWhy Poulan Pro Snow Blower losing power?
If your Poulan Pro Snow Blower is losing power, consider these potential causes: * A loose spark plug wire. Reconnect it. * Throwing too much snow. Reduce your speed and the width of the area you're clearing. * The fuel tank cap is covered with ice or snow. Remove the ice and snow from around the cap. * A dirty or clogged muffler. Clean or replace the muffler.
What to do if Poulan Pro Snow Blower has loss of snow discharge?
If your Poulan Pro Snow Blower experiences a loss or slowing of snow discharge, check the following: * The auger belt might be off the pulley. Check and reinstall it. * The auger belt might be worn. Check and replace it. * The discharge chute might be clogged. Clean the snow chute. * The augers or impeller might be jammed. Remove any debris or foreign objects.
Why does my Poulan Pro Snow Blower engine idles or runs roughly?
If your Poulan Pro Snow Blower engine idles or runs roughly, here are some possible reasons: * The choke might be in the FULL position. Move it to the OFF position. * There might be a blockage in the fuel line. Clean the fuel line. * The fuel might be stale. Drain the tank and refill with fresh, clean fuel. * There might be water in the fuel. Drain the fuel tank and carburetor, then refill the tank with fresh gasoline.
Why Poulan Pro 420915 has loss of traction?
If your Poulan Pro Snow Blower is experiencing a loss of traction drive or slowing of drive speed: * The drive belt might be worn. Check and replace the drive belt. * The drive belt might be off the pulley. Check and reinstall the drive belt.
Why is my Poulan Pro 420915 Snow Blower vibrating so much?
Excessive vibration in your Poulan Pro Snow Blower can be due to loose parts or damaged augers or impeller. Tighten all fasteners and replace any damaged parts.
General| Brand | Poulan Pro |
|---|---|
| Model | 420915 |
| Category | Snow Blower |
| Language | English |
