If your Poulan Pro Lawn Mower doesn't start, several factors could be at play. First, ensure you're following the correct starting procedure. Check for a clogged air filter, and clean or replace it if needed. Make sure there's fuel in the tank and that the fuel valve lever (if equipped) is in the ON position. Inspect the spark plug for defects and replace it if necessary, also check if the spark plug cable is connected. For models with a battery, ensure it's properly connected and charged. Finally, inspect for a loose blade or broken blade adapter and tighten or replace as necessary. If the engine brake handle is defective, it is best to contact an authorized service workshop.
D
Derrick DixonAug 6, 2025
What to do if starter rope hard to pull on Poulan Pro P160RWD?
M
Michael BryantAug 7, 2025
If the starter rope on your Poulan Pro Lawn Mower is hard to pull, ensure you depress the engine brake handle to the upper handle before pulling the starter rope. Other potential issues include a bent engine crankshaft or broken blade adapter, in which case you should contact an authorized service workshop or your service agent. Also, make sure you are using the correct starting procedure.
K
Kenneth BaileyAug 10, 2025
Why Poulan Pro P160RWD losing power?
H
Heather CohenAug 10, 2025
If your Poulan Pro Lawn Mower is losing power, there are several things to check. Make sure the cutting height isn't set too low and raise it if necessary. A clogged air filter can also cause power loss, so clean or replace it. Clear any buildup of grass, leaves, or trash from under the mower housing. Also, verify that the engine doesn't have too much oil. Lastly, ensure you're not walking too fast while mowing.
K
Kenneth MorrisonAug 15, 2025
Why is my Poulan Pro Lawn Mower so hard to push?
T
Thomas BuchananAug 15, 2025
If it's difficult to push your Poulan Pro Lawn Mower forward, especially when cutting extremely tall grass, raise the height of cut. Also, if the grass catcher is too full, empty it. If equipped, adjust the handle height to a comfortable position.
K
kellyjohnsonAug 19, 2025
How to fix uneven mowing with Poulan Pro Lawn Mower?
A
Anthony PatelAug 19, 2025
To address uneven mowing with your Poulan Pro Lawn Mower, start by inspecting the blade. If it's worn, bent, or loose, replace it. Next, check the wheel heights and ensure they are all set to the same level. Finally, clear any buildup of grass, leaves, or trash from underneath the mower housing.
R
rgallegosAug 23, 2025
Why is my Poulan Pro P160RWD vibrating so much?
H
hoffmanjessicaAug 23, 2025
If your Poulan Pro Lawn Mower is vibrating excessively, the blade may be worn, bent, or loose, so replace it if it is damaged. If the engine crankshaft is bent, contact an authorized service workshop.
G
Gloria FreemanAug 28, 2025
What to do if grass catcher not filling on Poulan Pro P160RWD Lawn Mower?
C
Christine ChambersAug 28, 2025
If your Poulan Pro Lawn Mower's grass catcher isn't filling properly, first check if the cutting height is too low and raise it if needed. Also, a worn blade can prevent proper filling, so replace it. Lastly, inspect the grass catcher to ensure it's venting air properly, and clean it if necessary.