Poulan Pro PB20A46YT - User Manual

Questions and Answers

P
Peggy NormanAug 20, 2025
How to fix Poulan Pro PB20A46YT Lawn Mower that will not start?
- M
  millerjonathanAug 20, 2025
  If your Poulan Pro Lawn Mower won't start, several factors could be the cause. First, ensure that the fuel tank is filled. If the engine isn't choked properly, consult the 'TO START ENGINE' section in the Operation section. If the engine is flooded, wait a few minutes before trying again. Other potential issues include a bad spark plug (replace it), a dirty air filter (clean or replace it), or a dirty fuel filter (replace it). Water in the fuel can also be a culprit; in this case, empty the fuel tank and carburetor, refill with fresh gasoline, and replace the fuel filter. Check all wiring for any loose or damaged connections. If none of these steps work, the engine valves may be out of adjustment, and you should contact an authorized service center/department.
J
John SmithAug 22, 2025
Why Poulan Pro PB20A46YT Lawn Mower is hard to start?
- Q
  qparksAug 22, 2025
  If your Poulan Pro Lawn Mower is hard to start, begin by checking the air filter and clean or replace it if it's dirty. A bad spark plug can also cause this issue, so replace it if necessary. Other potential causes include a weak or dead battery (recharge or replace it), a dirty fuel filter (replace it), or stale or dirty fuel (empty the fuel tank and refill with fresh, clean gas). Also, check all wiring for loose or damaged connections. If these steps don't resolve the issue, the engine valves may be out of adjustment, and you should contact an authorized service center/department.
C
Cynthia WelchAug 25, 2025
Why Poulan Pro PB20A46YT Lawn Mower engine will not turn over?
- K
  Kimberly ShahAug 25, 2025
  If the engine of your Poulan Pro Lawn Mower won't turn over, make sure the brake pedal is depressed. Also, ensure the attachment clutch is disengaged. Check the battery; if it's weak or dead, recharge or replace it. A blown fuse could also be the problem, so replace it if necessary. Clean any corrosion from the battery terminals. Inspect all wiring for loose or damaged connections. The ignition switch might be faulty, so check or replace it. Similarly, check or replace the solenoid or starter if they are faulty. If none of these steps work, the operator presence switch(es) may be faulty, and you should contact an authorized service center/department.
C
Charlene BatesAug 26, 2025
What to do if Poulan Pro PB20A46YT Lawn Mower engine clicks but will not start?
- B
  bphelpsAug 27, 2025
  If your Poulan Pro Lawn Mower engine clicks but doesn't start, the first thing to check is the battery. If it's weak or dead, recharge or replace it. Next, examine the battery terminals for corrosion and clean them if necessary. Also, inspect all wiring for loose or damaged connections. Finally, the solenoid or starter might be faulty, so check or replace them as needed.
D
Duane SmithAug 28, 2025
What to do if Poulan Pro Lawn Mower blades will not rotate?
- M
  Mr. Louis LoganAug 28, 2025
  If the mower blades of your Poulan Pro Lawn Mower won't rotate, there might be an obstruction in the clutch mechanism, so remove any obstruction. Another cause could be a worn or damaged mower drive belt, which would need to be replaced. Additionally, a frozen idler pulley or a frozen blade mandrel could be the problem, so replace them if necessary.
K
Kyle MorrisonSep 1, 2025
How to fix Poulan Pro PB20A46YT poor uneven cut?
- J
  James WallaceSep 1, 2025
  If your Poulan Pro Lawn Mower is leaving an uneven cut, the issue might be a worn, bent, or loose blade. Replace the blade and tighten the blade bolt. Another cause could be that the mower deck isn't level, so level the mower deck. Also, check for any buildup of grass, leaves, or trash under the mower and clean the underside of the mower housing. A bent blade mandrel can also lead to an uneven cut, so replace the blade mandrel if necessary. Lastly, clogged mower deck vent holes from buildup of grass, leaves, and trash around the mandrels can be the problem, so clean around the mandrels to open the vent holes.
J
James RamosSep 3, 2025
Why Poulan Pro PB20A46YT Lawn Mower has poor grass discharge?
- P
  perrymauriceSep 3, 2025
  If your Poulan Pro Lawn Mower has poor grass discharge, several factors could be the cause. First, ensure the engine speed isn't too slow by placing the throttle control in the 'FAST' position. If you're moving too fast, shift to a slower speed. Wet grass can also hinder discharge, so allow the grass to dry before mowing. Check that the mower deck is level and level it if necessary. Ensure tires have proper air pressure. Replace a worn, bent, or loose blade and tighten the blade bolt. Clean any buildup of grass, leaves, or trash under the mower. Replace a worn mower drive belt. Make sure blades are installed with the sharp edge down. Use the correct blades. Clean around mandrels to open vent holes if they are clogged.
A
Alan FischerSep 5, 2025
What causes excessive vibration in Poulan Pro Lawn Mower?
- J
  Julie SanchezSep 5, 2025
  If your Poulan Pro Lawn Mower is vibrating excessively, it could be due to a worn, bent, or loose blade. Replace the blade and tighten the blade bolt. Another possible cause is a bent blade mandrel, which would need to be replaced. Also, check for any loose or damaged parts, tighten any loose parts, and replace any damaged parts.
G
gwrightSep 7, 2025
Why Poulan Pro PB20A46YT Lawn Mower headlight(s) not working?
- J
  Jody ThompsonSep 7, 2025
  If the headlight(s) on your Poulan Pro Lawn Mower are not working, first check if the switch is 'OFF' and turn it 'ON'. If that's not the issue, the bulb(s) or lamp(s) may be burned out, so replace them. A faulty light switch could also be the cause, so check or replace it. Inspect the wiring and connections for any looseness or damage. Lastly, check if the fuse is blown and replace it if necessary.
A
angela08Sep 9, 2025
What to do if Poulan Pro PB20A46YT battery will not charge?
- K
  Kelly BrownSep 9, 2025
  If the battery of your Poulan Pro Lawn Mower will not charge, it could be due to bad battery cell(s), in which case you should replace the battery. Poor cable connections can also prevent charging, so check and clean all connections. If your mower is equipped with a regulator, a faulty regulator could be the problem, so replace it. Similarly, a faulty alternator could be the cause, so replace the alternator if necessary.

Poulan Pro PB20A46YT Specifications

General

Engine	Briggs & Stratton
Engine Displacement	500 cc
Transmission	Automatic
Deck Material	Steel
Cutting Height Positions	6
Drive System	Rear-wheel drive
Speed Settings	Variable
Oil Capacity	48 oz
Mulching Capability	Yes
Bagging Capability	Yes
Side Discharge Capability	Yes
Cutting Width	46 inches
Engine Type	4-Cycle