Poulan Pro PP4620AVX User Manual (English)

Questions and Answers:

A
Adam AllenJul 26, 2025
What to do if my Poulan Pro PP4620AVX Chainsaw engine will not start?
- K
  Kimberly RichardsonJul 26, 2025
  If your Poulan Pro Chainsaw engine won't start or runs only briefly, here are a few things to check: * Ensure the ignition switch is in the ON position. * Make sure the fuel tank isn't empty; if it is, fill it with the correct fuel mixture. * A spark plug that is not firing can also cause this issue; install a new spark plug. * Check if fuel is reaching the carburetor. A dirty fuel filter should be replaced and kinked or split fuel lines should be repaired or replaced. * The engine may be flooded. Refer to the “Difficult Starting” section in the Operation Section.
J
Jerry BradleyJul 31, 2025
Why Poulan Pro PP4620AVX engine will not accelerate?
- K
  Kari GardnerAug 1, 2025
  If your Poulan Pro Chainsaw engine lacks power, won't accelerate, or dies under load: * Begin by cleaning or replacing the air filter. * Clean, regap, or replace the spark plug. * Ensure the chain brake is disengaged. * The carburetor may need adjustment; contact an authorized service dealer.
E
Erik SheltonAug 6, 2025
What to do if Poulan Pro Chainsaw will not idle properly?
- D
  Dana ThomasAug 7, 2025
  If your Poulan Pro Chainsaw engine will not idle properly: * The carburetor may need adjustment; see “Carburetor Adjustment” in the Service and Adjustments Section. * Worn crankshaft seals can also cause idling issues; contact an authorized service dealer.
M
Matthew WagnerAug 12, 2025
Why is my Poulan Pro PP4620AVX smoking so much?
- A
  Adam BrightAug 13, 2025
  If your Poulan Pro Chainsaw smokes excessively, it's likely due to too much oil in the fuel mixture. Empty the fuel tank and refill it with the correct fuel mixture.
E
Eugene KnightAug 19, 2025
Why does my Poulan Pro Chainsaw chain move at idle speed?
- V
  vraymondAug 19, 2025
  If the chain on your Poulan Pro Chainsaw moves at idle speed: * The idle speed may need adjustment; see “Carburetor Adjustment” in the Service and Adjustments Section. * The clutch may require repair; contact an authorized service dealer.