Q: Does this case work with iPod touch models?
A: No, only iPhone 3GS/3G models. See PowerA.com for a
version that works with iPod touch.
iPhone doesn’t fit in Universal Remote Case
The Universal Remote Case works only with iPhone 3G and
iPhone GS models.
Universal Remote is not responding
• Your iPhone battery might be low. Recharge your phone
and try again.
• Check to see that the blue LED on the Universal Remote
lights up when a button is tapped. If the LED doesn’t light
up, data is not being transferred. Remove the iPhone
from the case, reinsert it, and try again.
• A button may not have been successfully programmed. Try
reprogramming the button. During programming, check
to see that the blue LED on the Universal Remote Case
flashes. If not, remove the iPhone from the case, reinsert
it, and try again. You might need to restart your iPhone.
Universal Remote won’t learn properly
If you are having trouble programming buttons, review
these tips:
• Buttons. Press the button on the Universal Remote once,
then briefly press the button on the remote control.
The blue LED on the Universal Remote flashes. Wait for
the “Button Learned” message before programming
another button.
• Distance. The remote control device should be four to six
inches from the Universal Remote during programming.
If signal is not being transferred, try placing the remotes
one to two inches apart or at a 45-degree angle.
• Batteries. Low batteries in your remote control device
can send a weak or erratic infrared signal that can’t be
received. Install new batteries and try again.
Troubleshooting
To Next Page
Loading...