Need help?Do you have a question about the Power Acoustik Gothic OV4-800 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| RMS Power @ 4 Ohms | 100W x 4 |
| RMS Power @ 2 Ohms | 200W x 4 |
| Bridged RMS Power @ 4 Ohms | 400W x 2 |
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| THD @ RMS Output | <0.05% |
| Damping Factor @ 4 Ohm | >150 |
| Selectable X-Over | Yes |
| Bass Boost | 0-12dB |
| Bass Boost Frequency | 45Hz |
| Max Power Output | 800W |
| Input Sensitivity | 200mV-6V |
| S/N Ratio | >95dB |
| Input Voltage | 0.2-6V |
| Low Pass Crossover Frequency | 50Hz - 250Hz |
| Signal to Noise Ratio | >95dB |
| Fuse Rating | 40A |
Overview of amplifier capabilities and manual importance for optimal performance.
Key attributes of the amplifier, including thermal protection, indicators, and connectivity options.
Warning about high volume levels causing hearing loss and potential traffic hazards.
Considerations for system expansion, input types, and component matching for optimal setup.
Guidelines for optimal amplifier placement for heat dissipation and air circulation.
Detailed steps for connecting the power supply, ground, and remote turn-on wires.
Connecting high-level (speaker) and low-level (RCA) audio inputs to the amplifier.
Function of the power indicator LED and the amplifier's protection circuit.
How to adjust the input sensitivity control for optimal signal-to-noise ratio.
Connecting speakers for standard stereo operation.
Connecting a subwoofer for mono operation.
Connecting for a subwoofer and main speakers in a mixed configuration.
Speaker wiring for a 4-channel amplifier setup.
Speaker wiring for a 3-channel amplifier setup.
Speaker wiring for a 2-channel amplifier setup.
Speaker wiring for a 6-channel amplifier setup.
To Next Page
