Need help?Do you have a question about the Power Acoustik Gothic OV4-600 and is the answer not in the manual?
General| Channel Configuration | 4-Channel |
|---|---|
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| Frequency Response | 10Hz - 30kHz |
| Total Harmonic Distortion (THD) | <0.05% |
| THD @ RMS Output | 0.05% |
| Input Voltage | 14.4V |
| Bass Boost Frequency | 45Hz |
| Peak Power | 600W |
| Signal to Noise Ratio | 90dB |
| Damping Factor @ 4 Ohm | >100 |
| Input Sensitivity | 200mV - 6V |
| Crossover Type | Variable |
| Bass Boost | 0dB - 12dB |
Warns about potential hearing damage and traffic hazards from high volume levels in vehicles.
Guidance on planning system expansion, input signal selection, component matching, and lead routing.
Recommendations for optimal amplifier mounting location to ensure proper heat dissipation and air circulation.
Details connecting the amplifier's power, ground, and remote turn-on wires to the vehicle's electrical system.
Guidance on connecting high-level audio inputs using speaker wires to the amplifier, with connection diagrams.
Instructions for connecting low-level audio inputs via RCA jacks, emphasizing cable routing for noise-free performance.
To Next Page