Why is the protection LED on (red) on my Power Acoustik Amplifier?
The protection LED (red) on your Power Acoustik Amplifier indicates a problem. It could be due to temperature shutdown, in which case you should turn the radio down. Alternatively, it might be due to a speaker wire short circuit, so separate the speaker wires and insulate them.
What to do if my Power Acoustik Amplifier is not switching on?
If your Power Acoustik Amplifier isn't turning on, it could be due to a few reasons. First, check if there's power to the power wire; if not, repair the wire or connections. Second, with the receiver on, ensure there's power to the remote wire; check the connections to the radio. Lastly, inspect the fuse and replace it if broken.
Why does my Power Acoustik Power PS2-420 have no sound?
If your Power Acoustik Amplifier has no sound, check the fuses in the amplifier and ensure the turn-on lead is connected. Also, inspect the signal leads and gain control, and verify the tuner/deck volume level. Clean the contacts on the fuse holders. Another possible cause is a speaker short or the amplifier overheating, so check for these issues as well.
What to do if Power Acoustik Power PS2-420 turns off at medium or high volume?
If your Power Acoustik Amplifier turns off at medium or high volume, ensure that you are observing the proper speaker load impedance recommendations.
How to fix no sound in one channel of Power Acoustik Power PS2-420?
If you're experiencing no sound in one channel of your Power Acoustik Amplifier, inspect for a short circuit or an open connection. You can also reverse the left and right RCA inputs to determine if the issue is occurring before the amp.
Dedicated subwoofer channel filter setting, adjustable crossover frequency from 40Hz to 250Hz.
Dedicated high-range channel filter, filters frequencies below 40Hz to 250Hz.
How to connect high-level inputs when RCA jacks are not used.
Connecting speakers in stereo configuration for amplifiers.
Connecting speakers in mono configuration for amplifiers.
Tri-mode operation for subwoofer and main speakers.
Troubleshooting steps for when the amplifier produces no sound.
Steps to diagnose why the amplifier is not powering on.
Diagnosing and resolving issues with sound on a single channel.
Troubleshooting the protection circuit and its indicators.
Technical specifications for the PS2 series amplifiers.
Technical specifications for the PS4 series amplifiers.
General| Channels | 2 |
|---|---|
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| Input Sensitivity | 200mV - 6V |
| Low-Pass Crossover Frequency | 50Hz - 250Hz |
| Bass Boost | 0 - 12dB |
| Bass Boost Frequency | 45Hz |
| Signal-to-Noise Ratio | 90dB |
| Crossover Type | Variable |
To Next Page