The following figure shows examples of the cable range area for the standard IEC hose in a parking lot
with the charger centralized:
Anchoring of the equipment
To anchor the charger, the user must use A2-70 stainless screws: two M5x50 for the braket and two
M5x45 with neoprene washer for the equipment, all them with expansion plugs; fixing them by applying
the recommended torque for mechanical connections according to the manufacturer's specification (see
"Torque and screw sizing" section).
For a correct installation follow these steps:
• First, drill the holes according to the measurements on the drawing depending on the frame. Check
that the equipment is correctly leveled.
To Next Page
Loading...