Cable entry plate
The different holes are prepared for cable access, both for power supply and communications cables.
The arrangement of the cables is showed below for each frame.
Frame 1:
The AC input connection enters the equipment through one of the holes on the right, highlighted in the
image with a rectangle; while the Ethernet cable enters is through one of the holes on the left, intended
for communications, highlighted in the image with an oval.
Frame 2:
The AC input connection enters the equipment through one of the holes highlighted in the image with
a circle (1); while the Ethernet cable enters through one of the holes for communications, highlighted
in the image with a rectangle (2). The central holes of the bottom wiring plate (3) are for the hose outlets
if the model includes them.
To Next Page
Loading...