CABLE ACCESS AND CONNECTIONS
Ethernet cable connection
Before opening any door, the equipment must be completely isolated, without any tension. Be
sure to follow the insulation guidelines and all safety instructions indicated in the "Safety
instructions" section. Please use all the indicated PPE. Otherwise, you may get an electric shock.
The Ethernet cable must be angled. Otherwise, it will not respect the bend radius
The customer must also carry out the communications connection. The Ethernet connection is made
in the central port of the card, highlighted by a square. In both frames, it is located at the same point
on the card, which is located at the top part of the unit.
Frame 1
Frame 2
To Next Page
Loading...