Power Electronics NB WALL Series - Current and Voltage Settings; Final Locking and Power-Up Procedure

POWER ELECTRONICS
NB Wall
COMMISSIONING
43
EN
Verify that the AC input voltage is compatible with the AC voltage range of the equipment.
Verify the selectivity of the external protections to the equipment and control parameters.
Activate the equipment´s internal protections
Make sure the door is properly locked.
If all previous steps are successful, start the charger and it is ready for use.
Adjust the charging current using an internal selector on the device.
Check “Charging current adjustment” section.
Provide power to the external power supply.
Set the available communications remotely.