What to do if Power-Genex SS2L show H/RX HA error?
If your Power-Genex Valve Positioners display 'H/RX HA' due to a HART signal failure, the system will automatically reset and reconnect after 2.5 seconds. However, if the error persists, it's crucial to thoroughly inspect the communication system to identify and resolve any underlying issues.
What to do if Power-Genex Valve Positioners show Fee FBSM error?
If the 'Fee FBSM' error appears on your Power-Genex Valve Positioners because the operating stroke is too small (2-9%) and the valve isn't working smoothly, you should reinstall the potentiometer and increase the operating angle of the feedback lever.
What to do if Power-Genex SS2L Valve Positioners show BAD error?
If your Power-Genex Valve Positioners display 'BAD', you should check the valve or consider increasing the response time of the PST.
What to do if Power-Genex Valve Positioners show Opera MONT error?
If your Power-Genex Valve Positioners display 'Opera MONT' during step 4 and the ting angle out auto-calibration process finishes out of range without completion, you should reinstall the SS2L / SS2R positioner.
What to do if Power-Genex SS2L Valve Positioners show LOTT error?
If your Power-Genex Valve Positioners display 'LOTT' because the valve is not closed or moves slowly, try loosening the valve packing.
Why Power-Genex SS2L Valve Positioners show IGMI Dow error?
If your Power-Genex Valve Positioners display 'IGMI Dow' because the actuator is too big, use the air volume booster.
How to troubleshoot RTQ error on Power-Genex Valve Positioners?
If your Power-Genex Valve Positioners display 'RTQ' due to a problem with the coil, you should check the coil assembly.
How to troubleshoot low CMLO on Power-Genex Valve Positioners?
Re-check the 4 – 20mA input signals on your Power-Genex Valve Positioners.
General safety instructions, hazard levels, and responsibilities for safe operation.
Details on product warranty, disclaimers, and compliance requirements for use.
Precautions for safe operation, handling, air supply, and environmental conditions.
Safety measures for maintenance and warnings about electrostatic charging hazards.
Description of parts, components, and the fundamental working principle of the positioner.
Comprehensive technical specifications including operating conditions and communication protocols.
Understanding order codes, nameplate details, and the functions of the LCD display and buttons.
Configuration of input signals, valve characteristics, span, and zero adjustments.
Instructions for mounting the positioner onto linear and rotary actuator types.
Guidelines for connecting pneumatic air supply and electrical wiring to the positioner.
Wiring procedures for micro switches, alarms, HART, Fieldbus, intrinsic safety, and earthing.
Step-by-step guide for auto-calibration and explanation of operating modes.
Description of main parameters and settings for control speed adjustment.
Adjusting PID gains, GROP gain, and control mode parameters for performance tuning.
Configuring dead band, alarm limits, signal calibration, and other advanced parameters.
Performing essential maintenance, preliminary checks, and identifying module parts.
Comprehensive list of error codes, their causes, and recommended actions for resolution.
Identification of spare parts for SS2L and SS2R models with diagrams and lists.
Detailed dimensional drawings and measurements for both SS2L and SS2R models.
General| Input Signal | 4-20 mA |
|---|---|
| Supply Pressure | 1.4 to 7 bar (20 to 100 psi) |
| Ambient Temperature | -20 ~ +70 degrees Celsius |
| Enclosure Rating | IP66 |
| Housing Material | Aluminum |
To Next Page
