Power Measurement 7330 ION - Configuring the 7330 ION with ION Designer

1%/-2+'32*-+96%8-32',%2+)7 r
'SRJMKYVMRKXLI-32[MXL-32(IWMKRIV
ION Designer software (part of Power Measurement’s PEGASYS suite) provides
the most powerful interface to the 7330 ION’s operating software. All of the
device’s ION modules can be accessed and configured using a standard
technique and a unified interface.
8LI1EMR-32'SRJMKYVEXMSR7GVIIR
If PEGASYS 2.0 has been properly configured, the screen below will appear in
each time that you open a 7330 ION in ION Designer. If PEGASYS has not yet
been configured, refer to the PEGASYS Administrator’s Guide, or contact your
PEGASYS network administrator.
9WMRK-32(I WM K RI VXS'LERKI 7 I X YT6I K M WXI VW
You require PEGASYS password level 5 to modify the settings in a module’s
setup register. If you do not have sufficient password authority, contact your
PEGASYS administrator.
Once you have logged on to ION Designer and you have opened the 7330 ION’s
node diagram, you can begin configuring ION modules. ION Designer displays
two types of objects on the main configuration screen: ION modules and
grouping objects (also called folders).
,21 PRGXOHV DSSHDU RQ
WKH ,21 'HVLJQHU VFUHHQ
JURXSHG E\ WKH IXQFWLRQV
WKH\ SHUIRUP 5LJKWFOLFN D
PRGXOH WR DFFHVV LWV 6HWXS
UHJLVWHUV
,21 'HVLJQHU GLVSOD\V D IROGHU
LFRQWRLQGLFDWHDGGLWLRQDOPRGXOHV
DUH DYDLODEOH 'RXEOHFOLFN IROGHUV
WR RSHQ WKHP DQG GLVSOD\ WKH
DGGLWLRQDOPRGXOHV