Power One 10kW-SGTU-103 User Manual

TRACKSO INSTALLATION GUIDE FOR POWER ONE INVERTERS
Brand: POWERONE
Type: Solar On Grid String Inverter
Models: 10kW-SGTU-103, 12.5kW-SGTU-1253, 15kW-SGTU-153, 17kW-SGTU-173, 20kW-SGTU-203, POM
SGTU 30kW, SGTU-333N, POM SGTU 50kW
DOCUMENT DETAILS
Following Document Explains Connections of TrackSo Logger with PowerOne Inverters for Following Type
1) 10kW-SGTU-103, 12.5kW-SGTU-1253, 15kW-SGTU-153, 17kW-SGTU-173, 20kW-SGTU-203, SGTU-333N
a. Type A- with RS485 Output
b. Type B- with RS232 Output
2) POM SGTU 30kW, POM SGTU 50kW, POM SGTU 60kW (RS485)
For a Modbus-RTU-RS232 type Inverter you will require logger with RS232 Communication port.
For a Modbus-RTU-RS485 type inverter you will require logger with RS485 Communication port.
Note:
Before Proceeding further kindly identify the Inverter type you are
connecting with the Datalogger and accordingly proceed with the instruction
mentioned for that model

Power One 10kW-SGTU-103 Specifications

General

Category	Inverter
Maximum DC Input Voltage	1000 V
AC Output Power	10 kW
Output Power	10 kW
Frequency	50/60 Hz
Number of MPP Trackers	2
Operating Temperature Range	-25°C to +60°C
Cooling	Fan
Protection	IP65

Summary

RS485 Connection Diagram

RS485 Connection Steps

Steps for connecting RS485 terminals to the TrackSo IoT Gateway.

Inverter Configuration Settings

Configuration steps for RS485 communication: baud rate, inverter ID, and date/time.

RS232 Connection Diagram

RS232 Connection Steps

Steps for connecting RS232 terminals to the TrackSo IoT Gateway.

RS232 Inverter Configuration

Configuration steps for RS232 communication: baud rate and inverter ID.

Setting RS232 Date and Time

Setting the correct date and time via the inverter's system parameter menu.

Multiple Inverter RS485 Setup

Multiple Inverter Connection Diagram

Diagram illustrating the daisy chain connection of multiple inverters.

Multiple Inverter Configuration

Configuring baud rate for multiple inverters connected via RS485.

Setting Multiple Inverter IDs

Assigning unique RS485 addresses to each inverter in a multi-inverter setup.

Setting Multiple Inverter Date/Time

Setting the correct date and time for each inverter in the network.

Setting Communication Protocol

Selecting the communication protocol, e.g., Modbus, for the inverter.

TrackSo Working and Status

TrackSo Device Setup

Steps for ensuring correct connections and inserting the SIM card.

LED Status Indicators

Description of LED indicators for Power, GSM, and communication status.

Checking Network Status via SMS

Sending an SMS command to check the device's network and connection status.

Verifying Data Reception

Checking the 'Units' section on the TrackSo platform for data reception status.

Troubleshooting Event Logs

Checking event ingestion logs for errors and troubleshooting data issues.