MAINTENANCE
WARNING: Disconnect the spark plug before performing any maintenance.
Check For Damaged Or Worn Parts
Contact customer service for replacement of damaged or worn parts.
ON/OFF Switch – Ensure ON/OFF switch functions properly by pushing and releasing the switch.
Make sure engine stops. Wait 5 seconds before attempting to restart unit to allow switch to reset.
Restart engine and continue.
Fuel Tank – Immediately discontinue use of unit if fuel tank shows signs of damage or leaks.
Debris Shield – Discontinue use of unit if debris shield is damaged.
Clean Air Filter
A dirty air filter will decrease engine performance and increases fuel consumption and harmful
emissions. It is important to clean the filter after every 5 hours of operation.
1. Clean the filter cover, and the area around it to keep dirt from falling into the carburetor chamber
when removed.
2. Press the tabs on the air filter cover to remove the cover and air filter.
NOTE: To avoid creating a fire hazard or producing harmful evaporate emissions, do not clean filter
in gasoline or other flammable solvent.
3. Wash the filter in soap and water.
4. Allow the filter thoroughly dry be for reinstalling.
5. Replace parts.
Replace Spark Plug
Replacing the spark plug each year will help ensure that the engine starts easier, and runs better. Set
spark plug gap at 0.023”~0.028”(0.6~0.7 mm). The ignition timing is fixed and does not require
adjustment.
Storage
CAUTION: Perform the following steps after each use:
● Allow engine to cool before storing or transporting.
● Store unit and fuel in a well-ventilated area where fuel vapors cannot reach sparks or open flames
from water heaters, electric motors or switches, furnaces, etc.
● Store unit with all guards in place. Position unit so that any sharp object cannot accidentally cause
injury.
● Store this unit and the fuel well out of the reach of children.
Prepare your unit for storage at the end of season or if it will not be used for 30 days or more. If your
unit is to be stored for a period of time:
1. Clean the entire unit before lengthy storage.
2. Store in a clean dry area.
To Next Page
Loading...
Need help?
General