Power USB
U S E R M A N U A L
Please read the PowerUSB Basic Manual for Software Installation
and Configuration of the unit with your computer. The SMART
model has all the features of the Basic model along with the LCD
display and standalone operation in several modes. This manual
describes only the additional features of the SMART model.
CAUTION
Please note that the PowerUSB unit is to be used for low to medium power devices and
not
for devices requiring a load peak of more than 16Amps. Following is the
recommended
outlet usage:
Outlet 1 (Modem): Max 4A (440Watt).
Low to Med loads. Light inductive loads. No Leakage current.
Outlet 2 (Monitor): Max 8A (880Watt).
High loads. High Inductance (Motor, Power Supply).
Leakage current of up to 3VAC due to snubber circuit.
Outlet 3 (Printer): Max 8A (880Watt).
High loads with medium inductance. Light Leakage current of up to 0.2VAC
The PowerUSB is protected from overloads with a reset switch for up to 8A.
CONTROLLED OUTLETS WILL BE SWITCHED OFF AND THE UNIT WILL GO
INTO OVERLOAD MODE WITH FLASHING OUTLET LEDs
THE UNIT HAS TO BE POWERED DOWN, USB CABLE REMOVED AND
RESET TO COME OUT OF OVERLOAD MODE.
To Next Page
Loading...