English (original instructions)
EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
String will not advance when using
the bump-feed head.
String is welded to itself. Lubricate with silicone spray.
Not enough string on spool. Install more string. Refer to string re-
placement earlier in this manual.
String is worn too short. Pull string while pressing line release
button.
String is tangled on spool. Remove string from spool and re-
wind. Refer to string replacement ear-
lier in this manual.
Grass wraps around shaft housing
and string head.
Cutting tall grass at ground level Cut tall grass from the top down to
prevent wrapping.
Motor fails to start when switch trigger
is depressed.
Battery is not secure. To secure the battery pack, make
sure the latch on bottom of the bat-
tery pack snaps into place.
Battery is not charged. Charge the battery pack according
to the instructions included with your
model.
Shaft not connected completely Make sure lower shaft is fully seated
in shaft coupler on upper shaft and
secure shaft coupler.
<6000
The maximum rotational frequency of
the spindle.
Noise value
Double-insulated construction
To Next Page
Loading...
