What to do if the exhaust temperature is too high on my Power World PHP12Hs-W Heat Pump?
If the Power World Heat Pump exhaust temperature is too high, you should first replace the compressor discharge temperature sensor. If the issue persists, reconnect or clean the compressor discharge temperature sensor, ensuring it's wrapped with insulation tape. As a last resort, consider replacing the controller or PC Board.
What to do if my Power World Heat Pump shows low pressure protection?
If your Power World Heat Pump is showing low pressure protection, first check for any gas leakage and refill the refrigerant if necessary. If the issue continues, consider replacing the filter or capillary.
What to do if the ambient temperature sensor fails on Power World PHP12Hs-W?
If the ambient temperature sensor fails on your Power World Heat Pump, you should check or change the sensor.
What to do if the exhaust temperature sensor fails on Power World PHP12Hs-W Heat Pump?
If the exhaust temperature sensor fails on your Power World Heat Pump, you should check or change the sensor.
What to do if the heating condenser sensor fails on Power World PHP12Hs-W?
If the heating condenser sensor fails on your Power World Heat Pump, you should check or change the sensor.
What to do if the inlet water temperature sensor fails on Power World PHP12Hs-W?
If the inlet water temperature sensor fails on your Power World Heat Pump, you should check or change the sensor.
What to do if the outlet water temperature sensor fails on Power World PHP12Hs-W?
If the outlet water temperature sensor fails on your Power World Heat Pump, you should check or change the sensor.
What to do if the gas return sensor fails on Power World PHP12Hs-W Heat Pump?
If the gas return sensor fails on your Power World Heat Pump, you should check or change the sensor.
Provides detailed technical specifications for various heat pump models.
Details on wiring, fuse/breaker requirements, and wire sizing.
Procedures for starting and operating the heat pump for the first time.
Detailed wiring diagram for the WiFi enabled swimming pool heat pump.
List of error codes displayed on the controller and their solutions.
Step-by-step guide for connecting the heat pump via WiFi on Android devices.
Step-by-step guide for connecting the heat pump via WiFi on iOS devices.
General| Model | PHP12Hs-W |
|---|---|
| Heating Capacity | 12 kW |
| Refrigerant | R410A |
| Weight | 85 kg |
| Type | Heat Pump |
| Power Supply | 220-240V, 50Hz |
| Noise Level | 52 dB |
To Next Page
