What to do if the exhaust temperature is too high on my Power World Heat Pump?
If the Power World Heat Pump exhaust temperature is too high, you should first replace the compressor discharge temperature sensor. If the issue persists, reconnect or clean the compressor discharge temperature sensor, ensuring it's wrapped with insulation tape. As a last resort, consider replacing the controller or PC Board.
What to do if my Power World PHP09Hs-W shows low pressure protection?
If your Power World Heat Pump is showing low pressure protection, first check for any gas leakage and refill the refrigerant if necessary. If the issue continues, consider replacing the filter or capillary.
What to do if the ambient temperature sensor fails on Power World PHP09Hs-W?
If the ambient temperature sensor fails on your Power World Heat Pump, you should check or change the sensor.
What to do if the exhaust temperature sensor fails on Power World PHP09Hs-W Heat Pump?
If the exhaust temperature sensor fails on your Power World Heat Pump, you should check or change the sensor.
What to do if the heating condenser sensor fails on Power World PHP09Hs-W Heat Pump?
If the heating condenser sensor fails on your Power World Heat Pump, you should check or change the sensor.
What to do if the inlet water temperature sensor fails on Power World PHP09Hs-W?
If the inlet water temperature sensor fails on your Power World Heat Pump, you should check or change the sensor.
What to do if the outlet water temperature sensor fails on Power World PHP09Hs-W Heat Pump?
If the outlet water temperature sensor fails on your Power World Heat Pump, you should check or change the sensor.
What to do if the gas return sensor fails on Power World PHP09Hs-W Heat Pump?
If the gas return sensor fails on your Power World Heat Pump, you should check or change the sensor.
Manual includes necessary information for use and installation. Follow instructions carefully to avoid danger.
Presents the wiring diagram for the WiFi swimming pool heat pump, differentiating customer and factory installation sections.
Lists common error codes displayed on the LED controller and provides corresponding solutions for malfunctions.
General| Model | PHP09Hs-W |
|---|---|
| Heating Capacity | 9 kW |
| Refrigerant | R410A |
| Max. Current | 15 A |
| Power Supply | 220-240V, 50Hz |
| Noise Level | 52 dB |
To Next Page
