20
Operation
When working with the machine, the appropriate plastic guard
hood for ‘cutting blade mode’ or ‘cutting line mode’ must be
fitted to prevent objects being thrown out.
The integrated blade in the cutting line guard hood
automatically cuts the line to the optimum length.
ATTENTION! Before operating, you must fill the machine
with fuel.
Starting the unit
Do not start the cutter until it has been completely assembled.
Danger of injury!
Do not operate the device unless you did not find any faults. If a
part has become defective, be sure to replace it before you use
the device again.
Check before use!
Check the safe condition of the machine.
Check the machine for leaks.
Check the machine for visual defects.
Check that all parts of the machine have been securely fitted.
Check that all safety devices are in proper condition.
Danger of injury!
Before starting work, always check the ground and remove all
objects which could be thrown by the machine.
Start
Once the machine has been set up properly, start the engine as
follows:
1. Set the machine down on a hard, level surface.
2. Turn the engine switch to the ‘I’ position.
To Next Page
Loading...